Co2 Monitor: Unterschied zwischen den Versionen
(Die Seite wurde neu angelegt: „{{Infobox Projekt |name = CO²Monitor |status = stable |autor = schinken |beschreibung = IoT CO² Sensor…“) |
(kein Unterschied)
|
Version vom 4. November 2017, 19:24 Uhr
CO²Monitor Status: stable | |
---|---|
![]() | |
Beschreibung | IoT CO² Sensor |
Autor: | schinken |
PayPal | ![]() |
Description
Someday a TFA Dostmann CO2-Sensor AirCO2ntrol appeared in our hackerspace - but the CO² reading couldn't be easily acquired through USB or any other connector. There are some implementations using python or nodejs, but they require a raspberry pi or at least a PC nearby to read the values to publish and store them somewhere.
Because nowadays ESP8266, NodeMCU or in our case a Wemos D1 mini (which also has a ESP8266 on it) exist and is totally suitable for the job! Sadly, on the TFA Dostmann there's only a USB interface on the outside, and our Microcontroller does not support USB natively. So we opened the sensor and found a "CALIB" interface
Hardware
Inside the TDA Dostmann CO² sensor, there's a CALIB interface, which consist of four PINs. GND and 5V can easily be determined using a multimeter with continuity test. These PINs are directly connected to the USB port and can be used to power our microcontroller. The other 2 PINs in the middle seem to send some data. After connecting them to a oscilloscope one PIN was obviously just clock, and the other data.
Software
The signals look like they're just I2C, but actually they're not. Using the scope to decode the data failed - the same is true using the Wemos. After wiring up the sensor to the Wemos we used an external interrupt on the clock pin and a digitalRead on the data pin which is basically "bit banging".
The results were promising: Using a simple python script and the documentation from another manufacturer, we were able to verify the checksum. Also implementing the decode of the data was quite simple using the PDF:
case 0x50: co2Measurement = (data[IDX_MSB] << 8) | data[IDX_LSB]; break; case 0x42: temperature = ((data[IDX_MSB] << 8) | data[IDX_LSB]) / 16.0 - 273.15; break;
The last thing to do was connecting to wifi and publishing the data on MQTT.